Fujitsu FR Family FR60 Lite, User Manual

Page: 586 / 1038

570
Chapter 31 External Bus
5.Operation of the Ordinary bus interface
• If synchronous write enable output is used, the following restrictions apply:
Do not set the following additional wait because the timing for synchronous write enable output becomes
meaningless:
- CS -> RD/WRn setup (Always write 0 to the W01 bit of AWR)
- First wait cycle setting (Always write 0000 to bits W15-W12 of AWR)
Do not set the following access types (TYPE3-0 bits (Bits 3-0) in the ACR register) because the timing for
synchronous write enable output becomes meaningless:
- Multiplex bus setting (Always write 0 to the TYPE2 bit of ACR)
- RDY input enable setting (Always write 0 to the TYPE0 bit of ACR)
Always set the burst length to "1" (BST1 to 0 bit = 0) for the synchronous write enable output
5.8 CSn Delay Setting
This section shows the operation timing for the CSn delay setting.
■
Operation Timing for the CS Delay Setting
Figure 5-8 "Operation Timing Chart for the CS Delay Setting" shows the operation timing for (TYP3-0=0000
B
,
AWR=000C
H
).
Figure 5-8 Operation Timing Chart for the CS Delay Setting
If the W02 bit is 1, assertion starts in the cycle following the cycle in which AS is asserted. For successive
accesses, a negation period is inserted.
READ
WRITE
MCLK
AS
CSn
RD
D[31:0]
WRn
D[31:0]
A[31:0]