Chapter 5 Daily Care
66
Cleaning the ADF (with Cleaning Paper)
The ADF can be cleaned with a sheet of Cleaning Paper
moistened with Cleaner F1.
As the scanner continues to feed the documents, paper dust
will accumulate inside the ADF and it may cause scanning
errors.
Cleaning should be performed approximately every 3,000
sheets scanned. Note that this guideline varies depending on
the types of documents you scan. For instance, it may be
necessary to clean the scanner more frequently when you
scan documents on which the toner is not sufficiently fused.
1
Turn on the scanner.
For details, refer to
"1.3 Turning the Power ON/OFF" (page 19)
.
2
Spray the Cleaning Paper with Cleaner F1.
3
Pull out the chute extensions according to the length of
the Cleaning Paper.
For details, refer to
"1.5 Setting Up the ADF Paper Chute (Feeder)"
4
Bring down the stacker and slide out the stacker
extension towards you according to the length of the
Cleaning Paper.
For details, refer to
"1.6 Setting Up the Stacker" (page 23)
.
5
Load the Cleaning Paper in the ADF paper chute (feeder).
6
Adjust the side guides to the width of the Cleaning Paper.
Do not leave space between the side guides and the Cleaning Paper.
Otherwise, the Cleaning Paper may be fed skewed.
5.3 Cleaning the Inside
ATTENTION
Do not use water or mild detergent to clean the ADF.
It may take a long time to dry if an excessive amount of Cleaner F1 is
used. Use it in small quantity.
Side Guides
