FujiFilm FRONTIER 390, Instruction Manual

Page: 134 / 173

136
No. Message Action to Take
Adjust room temperature to within indicated
range.
Check the communication cable connection
and re-try. If the error recurs, reinstall
system software.
See section 7.2
Remove paper in the cutter section.
Remove paper in the processor or dryer
section (see subsection 7.2). After removal,
open and close the processor cover once.
Remove paper in the cutter section.
Consult technical representative.
The laser’s temperature adjustment cannot be
performed, because the ambient temperature
is too low(high).
Adjust the ambient temperature between 15-C
and 30-C.
(The laser’s temperature adjustment is started
if the ambient temperature exceeds 5-C.)
Transferring images from scanner has not
been completed within a specified time.
Transferring of images was aborted.
(Code No. = %NUM%)
Paper jam in processor (7).
Remove paper.
Check it. %NUM% strips remains.
Paper jamming occurred in the cutter section.
Remove paper.
Paper remains in the processor or the dryer
section.
Remove paper.
Open and Close Processor cover once.
Paper remains in the cutter section.
Remove paper.
Slant sorter malfunctions.
Call technical representative.
Horizontal sorter malfunctions.
Call technical representative.
Cutter malfunctions.
Call technical representative.
Hole punch not detected in the cutter section.
Call technical representative.
Paper width guide in the cutter section
malfunctions.
Call technical representative.
Loop guide in the cutter section malfunctions.
Call technical representative.
Width guide in processor malfunctions.
Call technical representative.
Exit guide malfunctions.
Call technical representative.
Communication error occurred in printer
(between main circuit board and processor
section).
Call technical representative.
Processor program error.
Call technical representative.
W-2537
W-2539
W-2540
W-2601
W-2602
W-2603
W-2604
E-2605
E-2606
E-2607
E-2608
E-2609
E-2610
E-2611
E-2612
E-2614
E-2615