Fuji Electric ZSS-7, Instruction Manual

Page: 28 / 116

INZ-TN7ZSS-E
- 21 -
4.7.2 How to operate the angle adjustment unit 2
This section describes movement of the optical axis by operating the angle adjustment unit.
Example) When you adjust the fixing bolt and the anchor nut shown in the figure below, encircled with a
solid line
(1) If the flange A and the flange B are parallel, the laser beam points horizontal direction.
(2) If you screw up the fixing bolt tightly as the figure below, the place where the bolt is screwed up in-
clines to the right, and the laser beam points upward.
(3) If you loosen the fixing bolt as the figure below, the place where the bolt is loosen parts from the flange
A, and the laser beam point downward.
・
In the same way, when you adjust the black-out fixing bolt and anchor shown in the figure below as
“4.7.2.2-2) and 3)”, the light axis moves as follow.
・
In the same way, when you adjust the black-out fixing bolt and anchor shown in the figure below as
“4.7.2.2-2) and 3)”, the light axis moves as follow.