FT500 SFI / FT500LITE SFI
87
Interface settings
23.2 LCD blacklight settings
Adjust LCD brightness and select between night and day modes.
LCD Backlight settings
Day Mode
100%
Nigth Mode
36%
23.3 Alert sound settings
This parameter allows for setting the volume of sounds generated by
touching the display. When the mute option is selected, the ECU is
silent when the screen is touched.
Alert Sound settings
Interface sound volume
100%
Alerts sound volume
36%
23.4 Dashboard setup
There are 24 configurable positions on the dashboard, with minimal
size of 1x1. It’s possible to select sizes as 1x2, 2x1 and 2x2.
First, select the position where you want the information to be, then
the reading that will be displayed and the reading size.
Display configuration 1/5
Turn on
Burnout
°C
ECT
98
Data
Inj.T.A
5.25
ms
V
Battery
13,5
Fuel Press.
0,05
2,47
-0,85
bar
IAT
55
°C
Oil P.
55
psi
105
10930
7325
RPM
2
3
4
5
6
8
9
10
1
7
11
ECT
95
°C
Free
Free
Free
Free
Free
Free
Free
Display configuration 2/5
TPS
Information select:
MAP
O2 Sensor #1
Oil Pressure
Fuel Pressure
Exhibition limits and alerts
On some sensors, changes his color to indicate something is wrong.
The readings with this options are: MAP, air temperature, engine
temperature, battery voltage, fuel pressure, oil pressure, TPS, dwell,
ignition timing, primary injection time, secondary injection time, O2
sensor 1, O2 sensor 2 and delta TPS
Display configuration 5/5
Alert over:
Alert lower:
98
°C
0
°C
Disab.
Enab.
Disab.
Enab.
RPM bar
When clicking the RPM bar parameter, it is possible to setup the RPM
where the red zone starts.
Display configuration
Red zone RPM
5500
RPM
23. Interface settings
Allows the configuration of all the visual functions of the FT500, like
dashboard and day/night mode selection.
23.1 Day/night mode selection
There are 4 options to select from:
Day mode:
Display the screen brightness according to the value set
on the "Day mode" slider on the LCD Backlight settings.
Night mode:
Display the screen brightness according to the value set
on the "Night mode" slider on the LCD Backlight settings.
Dashboard:
Allows for a button to be set up to show on the dashboard
to change between "Day mode" and "Night mode"
Day/night external switch:
With this option, one of the white inputs
must be wired to the vehicles light switch and properly set up on the
inputs menu.
Dashboard
Day/night
external switch
Day mode
Night mode
Selection
Day/night mode selection 1/3
None
Input selection
White
O2 General
1:
White 2: 2-step
White
i C
tioning
3: A r ondi
White
Oil pressure
4:
Day/night mode selection 2/3
Activated at 0V
Activated at 12V
Signal for night mode
Day/night mode selection 3/3
NOTE:
From the version 3.10 onwards, it's possible to
configure the dashoard screen directly on the
software by clicking on the free squares and editing
the functions.
23.5 Startup screen selection
Select the screen shown right after the ECU is turned on. In case the
option “Open the main menu after startup” is selected and the ECU is
set up with a user password, the ECU will ask for the user password.
