FT500 SFI / FT500LITE SFI
75
19.16 Start button
This function allows the control of the vehicle's starter motor through
an output(blue, gray or yellow wires) and an input wire(white wire)
or through the FT screen.
Select whether you want to start the engine through the FT LCD screen
(must setup the "start button" item on the FT dashboard)or through
an external switch.
If Dashboard is chosen, the starter motor remains engaged while the
button is being pressed and until the engine RPM goes above the
Disabled
Enabled
DashBoard
External button
Botão de partida 1/4
Start button 2/4
Grey 7: Avaliable
Grey 8: Avaliable
Yellow 1: Avaliable
Yellow 2: Avaliable
Output selection
Test output:
Test
None
Input selection
White 1: O2 general
White 2: 2-step
White 3: Front left wheel
White 4: Oil pressure
Start button 3/4
Activated at 12V
Activated at 0V
Output activation
Activated at 12V
Activated at 0V
Input activation
Start button 4/4
When external switch is selected, chose whether the input is activated
when it receives 0V (ground) or 12V.
The output that activates the starter relay can be programmed wheter
to send 0V or 12V when activated.
"RPM for engine start" (set in the engine setup menu). As soon as
the engine is running, the function of the button on the dashboard is
now changed to "turn the engine off" when pressed(by cutting fuel
and spark).
Other functions
20. Drag race features
This menu gathers all options normally used in drag race applications.
All the time based features start after releasing the 2-step button which
indicates the moment when the vehicle launched.
20.1 Burnout mode
The Burnout Mode is a function used to facilitate the processes of
warming up the tires and using the two-step.
When pressing the two-step button, the two-step function is activated.
Disabled
Enabled
Burnout 1/3
7500
RPM
4000
RPM
Burnout rev limiter
Rev limiter
When Burnout mode is activated, it disables the standard RPM Limiter,
instead the ECU uses this RPM limiter as the engine’s RPM limit.
Burnout 2-step
fuel enrichment
Burnout 2/3
Lock 2-step
ignition timing at:
45
%
-16,0
°
Map
Fixed
Disabled
Enabled
Burnout 3/3
Turn off burnout
mode when
goes down of:
RPM
2000
RPM
Burnout 3/5
Burnout activation mode
Burnout external button
Burnout external switch
DashBoard
But when the two-step button is being pressed, the value considered
is the one set for the two-step parameter. The values adopted for
ignition timing retard and enrichment are the ones configured on the
two-step function.
