FT500 SFI / FT500LITE SFI
23
Engine settings
Pedal / Throttle 1/9
Electronic Throttle code
TPS
None
ETC
0500020010002001
Pedal / Throttle 1/9
Electronic Throttle code
TPS
None
ETC
1
2
3
4
5
6
7
8
9
0
0500020010002001
TPS
When using a throttle drived by cable with a potentiometer on the
throttle shaft select the TPS option.
Standard input for TPS sensor signal is #11, but it is possible to set
this input on any available input. Pedal/Throttle calibration must be
performed as shown in chapter 12.4
White 7: Air temperature
TPS
FT
input selection: default white #11 on
400
White 11: Avaliable
White 9: Avaliable
White 10: Avaliable
White 8: Avaliable
Pedal / Throttle 2/9
Electronic throttle control ETC
First data to be inserted on the ECU when using electronic Throttle
is its code (not the throttle part number). This code is found on the
FTManager Software. If your throttle is not on the list, please, contact
our tech support to check compatibility first.
Throttle position sensor input
If the map is generated in the FTManager software the ETC inputs
will be automatically allocated and can be checked in “Sensors and
Calibration” menu, then “Inputs”.
Injector’s total flow
Fuel injection 3/6
Injectors total flow
Primary
320
lb/h
Edit unit
Total flow is a sum of injectors
flow at the bank.
That’s the total flow of all injectors on the bank (primary or secondary).
This data is used to allow adition of some fuel tables in lb/hr I.e. four 80
lb/hr injectors on primary bank have a total flow of 320 lb/hr (80 x 4).
Fuel type
Fuel injection 6/6
Fuel type
Fuel injector
phase reference:
Fuel injector
opening
Fuel injector
closing
E85
Race gas
Alcohol
Pump gas
Select the fuel used on the motor. This information is used to create
a better base map
Fuel injection phase reference
Select if the Fuel injection phase angle table will be based on the
injectors opening or closing. The angular distance is the measure
between the ignition TDC of each cylinder and the moment the injector
should open or close
Fuel injector opening:
in this option it is only possible to know the
angle the injector will open, but, its closure will vary according to
injection time and RPM, this means that, depending on these factors,
the fuel injection may still be occurring even after the intake valve
has closed
Fuel injector closing (default):
This is the most commonly used
option as the fuel injection always occurs before the end of the intake
cycle, no matter the injection time or RPM.
7.5 Pedal/Throttle
Select the option “TPS” when using a mechanical throttle, driven by
cable.
After inserting the Throttle code, set the input that will be connected
to the throttle position sensor, usually there are two signals on the
throttle. Standard inputs are wires white #11 (Throttle signal #1A)
and white #10 (Throttle signal #1B).
