73
EN
To display the actual welding current during welding:
-
Press the "Parameter selection" button to select the welding current parameter
-
The actual welding current is shown on the digital display during welding.
Open the gas cylinder valve
Setting the shielding gas flow rate:
-
Tap the "Gas-test" button
-
Turn the adjusting screw on the underside of the pressure regulator until the pres-
sure gauge shows the required gas flow rate
-
Tap the "Gas-test" button again
Press the torch trigger and start welding
Corrections dur-
ing welding
To obtain the best possible welding results, the arc-force dynamic parameter will some-
times need to be adjusted.
Press the "Parameter selection" button to select the arc-force dynamic parameter
Use the adjusting dial to set the desired arc-force dynamic value
The welding parameter value is shown in the digital display located above it.
CAUTION!
Risk of injury and damage from electric shock and from the wire elec-
trode emerging from the torch. When pressing the torch trigger
-
keep the welding torch away from your face and body
-
wear suitable protective goggles
-
do not point the welding torch at people
-
make sure that the wire electrode does not touch any conductive or earthed
parts (e.g. housing)
7
8
9
1
2
Summary of Contents for TransSteel 2500c
