FROMM
FROMM
FROMM
FROMM
FS4.1893-Manual-30.18XX.02-EN-Version02_R1
It is forbidden to duplicate this manual or parts of it in any way or any form without written permission of the author © 2013
www.fromm-stretch.com
66
MAINTENANCE INSTRUCTIONS
YEARLY MAINTENANCE
Check the wear condition of the sliding wheels of the turntable :
Unscrew the 3 fixing bolts of the turntable. Move the disk aside.
You may also move the turntable using a truck or overhead gantry
by first screwing.
Insert the lifting eyebolts into the specific threaded holes and
release the turntable by unscrew the 3 fixing bolts of the turntable.
Insert the hooks of the lifting ropes into the eyebolts. Lift the
turntable using suitable load bearing lifting equipment.
Lubricate the rolls with grease applied carefully with a brush.
After checked all the rolls move the disk on on the center of the
turntable and secure it screwing the 3 bolts.
Check the wear condition of the wheels and replace them if
required (insert them by pressing them in place).
Check the function of the lock mechanism of the housing. On
turning the handle, the axles (1) should easily move upward and
downward. If there is resistance that may be due to the lock device
(2) having loosened or been slightly twisted. Ensure that it sits
vertically (not at an angle). Check the function again. If the lock
mechanism moves
smoothly but meets resistance when the housing is closed, it could
be due to the housing being warped. In which case, twist it back by
taking the upper and lower parts and twisting them carefully. To
adjust the axles (1), first loosen the locking nuts (3) and then turn
the axles. When extended to their maximum distance they must
come plane to the other side of the apertures in the pre stretch unit
chassis. No further!
