FROMM
FROMM
FROMM
FROMM
FS4.1893-Manual-30.18XX.02-EN-Version02_R1
It is forbidden to duplicate this manual or parts of it in any way or any form without written permission of the author © 2013
www.fromm-stretch.com
54
ERRORS DURING OPERATION
THE MACHINE DOESN’T WRAP THE COMPLETE PALLET
Problem suggestion
Possible solution
- Photocell is looking thru some holes in the pallet.
- Change photocell delay.
- Press button (1) (
Fig. 1
) and increase the
value with + (2) or decrease with the
minus button. (3) (
Fig. 2 & 3
)
Fig.1
Fig. 2
Fig. 3
- Program Pre-set height has been selected
- LED = ON (1) (
Fig. 1
)
- Press button (1) (
Fig. 1
) and within 2
seconds, press button (2) (
Fig. 2
) and
decrease the value until the LED (1) (
Fig. 1
)
will switch off.
Fig.1
Fig. 2
Should the problem persist, contact the Customer After-Sales Service of MANUFACTURER
THE MACHINE DOESN’T START WRAPPING
Problem suggestion
Possible solution
- There is not pallet on the table error E7
- Place a pallet
- Photocell is looking over the product error E7
- The pallet is lower than 600mm. Change the
program to the program with fixed height.
- The pallet is wrapped in black stretch-film
- Change the photocell to the type N5.2638
- The pallet contains black boxes or black
products. (Dark products with LOW or NO
refelction)
-
Try to move by JOG function the table. After
moving approx 20cm try to re-start the
program.
-
If the machine starts and doesn’t finish the
complete cycle, try to change the delay time
of the sensor as previously described.
-
Change the photocell to the type N3.2638
or N5.2651
1
2
3
1
2