FS4.1893-Manual-30.18XX.02-EN-Version02_R1
FROMM
It is forbidden to duplicate this manual or parts of it in any way or any form without written permission of the author © 2013
www.fromm-stretch.com
25
INSTALLATION INSTRUCTION
ATTENTION!
All mentioned activities may only be executed under supervision of qualified personnel from the
manufacturer or his representatives!
FOR EVERYTHING IS VALID: IF APPLIED!
Due to shipping requirements, the shaft is usually shipped horizontally and bears on a support
that has been specifically set up for it. Consequently the shaft must be re-positioned when the
machine is installed.
-
Upon having located the machine, lift the shaft (
Fig. 1
) by turning it around the fulcrum shaft
that has been specifically setup and then locate the shaft upright as compared to the turntable
-
Secure the shaft vertically to the relative plate with the four screws (3) (
Fig. 2
)
-
Tighten the four stabilizing screws (3) (Figure 2)
Fig. 1
Erect the mast using an overhead gantry or a truck.
Screw an M12 eyebolts on top of the mast (1) (
Fig. 1
),
where is located the M12 hole treaded.
Attach a strong hoisting (1) (
Fig. 1
)
Strap (1) to the gantry and lift it slightly so that mast
just leaves its support (4) on the turntable (3).
Fig. 2
Tighten the four screws (1) (
Fig.2
)
Equipment:
Standard tool size 17 (Bolt M10)
1
1
1
1
