FS4.1893-Manual-30.18XX.02-EN-Version02_R1
FROMM
It is forbidden to duplicate this manual or parts of it in any way or any form without written permission of the author © 2013
www.fromm-stretch.com
27
INSTALLATION INSTRUCTION
Machines suitable for pallets heights higher than 2.800mm are highly recommended to be fixed on
the floor. There are no PRE-DRILLED holes in the machine base. Holes have to be drilled by an
responsible installation engineer.
Installation materials have to be ordered separately. Or sourced in a local market.
Fig. 1
Fig. 2
Release the carriage which has been mechanically blocked to prevent damages on the cover during
the transportation of the machine.
-
Release the bracket (1) connected with two bolts M8 at the mast;
(Standard tool size 13)(
Nr 2 in Figures 1 / 2 & 3
).
A warning label (3) has been mounted on the mast.
-
Ones released, the two nuts will slide down in the corresponding profile of the mast (4) (
Fig.3
).
At the below position of the mast they will be kept / stocked for future use.
The bracket (1) must be stored in the electrical box, for eventual future use.
-
Should the need arise to transport the machine with the colon hinged in the horizontal way, we
strongly advice to remount the bracket (1) (
Fig. 2 & 3
);
-
Prior to hinge the column, remount the bracket (1) (
Fig. 3
) at an height of 1015mm. (Top) (Fig.4)
-
Move the carriage (5) (
Fig. 3
) with the manual ARROW up button, until it mechanically blocks
against the bottom of the bracket (1) (
Fig. 2 & 3
)
-
Disconnect the power supply and start dismantling the machine;
-
Following above recommendations, prevents damages on turntable and carriage cover during
transport.
Fig. 1
Fig. 2
Fig.3
Fig. 4
1
2
2
2
1
1
4
5
3
