Ø 15mm
❒
When the unit has been screwed together, insert it through the hole in the wall on
the store side
❒
Align the stirring head with the troughs in the store in accordance with the
installation diagram
Secure the agitator head to the floor:
❒
Make two holes each in the floor for the gear supports
❒
Drill the holes marked
- Drill diameter: 15 mm
- Drill depth at least 105 mm
❒
Insert the heavy duty anchors into the bore holes and tighten with a spanner (SW
17 mm)
Ø 15mm
❒
Fit adjustable feet on both sides of the open trough
Secure the adjustable feet to the floor:
❒
Make a hole in the floor for the adjustable feet
❒
Drill the holes marked
- Drill diameter: 15 mm
- Drill depth at least 105 mm
❒
Insert the heavy duty anchors into the bore holes and tighten with a spanner (SW
17 mm)
❒
Shorten the adjustable feet using an angle grinder so that the rotary agitator arms
are not obstructed
❒
Fit the closed trough with ceramic fibre seal to the transfer channel
➥
Check the alignment of the flange plates!
Assembly
4
Assembling the articulated arm rotary agitator
Installation and Operating Instructions GAR 110 / 150 | M2060120_en
21
