- 15 -
Options:
-Tap and select different Slices, which will all have G-Move applied to them while G-Move is active.
-Hold PlayFX >1 second to exit back to Slice playing.
-Hold Slice >1 second to exit both Slice and PlayFX (G-Move in this case) back to RP Sample.
-Adjust GM forward some to get a Time scaled playback of the slice.
*Any slice played will have this GM setting while GM is selected.
*Note: PlayFX Loop off method doesn't Exit with G-Move, as there is no defined "end" point.
7) Granulizing/MiniLooping for Echo
If a PLAY FX is started during a running Echo Mode, and echo is long enough, while the PLAY FX is brief enough
(less than the echo time), this PlayFX sound will be echo'ed along with any audio input present.
If PlayFX Loop is off, the PlayFX will "1-shot" out a single play defined by the start-end knobs. This is key to
reversing a sample (ST/END mode) as it allows a smooth transition.
Depending on the PLAY FX mode, the way the play point is handled changes as follows:
Start/End or Pos/Size: relative positions in last echo cycle (present record minus echo delay time)
G-Move: Starts exactly 1 echo cycle back from present position.
This can be used for cyclic effects if Echo is then set to "Infinite Echo". The example is to use POS and Size:
1
-Start an RP Echo as described in Section A. and make it long, say 5 seconds or more.
2
-Tap P.SEL to select the POS LED and turn on PLAY LOOP (Yellow) LED if not already on.
3
-Set The POSition and SIZE knobs to relative values to describe the MiniLoop in the echo cycle.
4
-Hold PLAY button at any time in the echo (Remember POS will choose the MiniLoop Position in echo)
5
-After a second or two, release the PLAY button to exit the MiniLoop
The MiniLoop should now be punched into the echo.
Options:
-Try this with G-Move and Start/End Play FX Modes.
-Turn off Play LOOP LED so the PlayFX loop exits by itself. This is useful for longer echos.
* This can also be done in LAYER RP Mode while recording a new layer. if within loop time.
8) Reversing Echo
A desirable effect with echoing/delaying is the ability to reverse an echo and have it included in the delay train.
This is easy with the Reflex as shown in this example.
1
-Select PlayFX mode Start/End (ST) with the P.SEL button,
2
-Set the top knob fully clockwise, and the bottom knob fully counterclockwise
3
-Tap the Loop button to turn ON PlayFX loop LED
4
-Start an RP Echo as described in Section A. with some sound input to the AC in's.
5
-At the point you want to reverse, tap the Play button to start looping
6
-At the point you want to return to echoing, turn OFF the PlayFX Loop LED. PlayFX will exit
*There will now be a smooth transition with everything playing in reverse as an echo.
7
-Turn PlayFX Loop LED back on to reset playFX (unless you want to recall this loop.!)
-Repeat Steps 5 - 7 to reverse back to forward
Options:
You can play a reverse with the playFX Loop LED off, but it may not be as smooth as it may have
not yet completed a cycle, and could include the abrupt entry point. Give it a try!
An earlier echo can also be recalled if PlayFX Loop is left off. Turning it on will reset.
