Fresenius Medical Care 5008, Operating Instructions Manual

Page: 124 / 328

Chapter 6: Treatment
6-12 Fresenius Medical Care 5008 OP 5/09.06
Check the bolus parameters.
Set the desired bolus parameters. Touch the
OK button to confirm the
values entered. Visually check the confirmed values.
Touch the Bolus I/O button to turn the bolus function on or off. (The
cumulated bolus amount is displayed in increments of 30 ml.)
Touch the TREATMENT menu button to return to the TREATMENT
SCREEN.
Message: No blood detected. – Dialysis Continue – Reinfusion Start –
Machine Remove lines
The blood pump stops. The arterial/venous occlusion clamp closes.
Mute LED is flashing. Audible signal
Touch the Continue button to go on with the dialysis treatment.
6.3.4 Changing the Single-Needle Parameters
In the SINGLE-NEEDLE menu
If you wish to alter Single-Needle parameters:
Set the desired Single-Needle parameters. Touch the
OK button to
confirm the values entered.
Visually check the confirmed values.
Touch the TREATMENT menu button to return to the TREATMENT
SCREEN.
6.3.5 Setting the Level in the SN Chamber
In the BLOOD SYSTEM menu
Touch the
VW
button on the Single-Needle chamber displayed on the
screen.
Message: Set the level in the SN chamber to the mark.
V
Level
W
–
Level set OK – Abort
Touch the
V
or
W
button to set the level to the mark of the SN chamber
holder.
(The doors must be closed.)
Touch the OK button.
Note
When administering larger volumes of substitution fluid, the blood may
be diluted to an extent which causes the optical detector to sense light.
Note
Do not lower the level in the SN chamber manually, but only as
described below.