Fostex PD606, Owner'S Manual

Page: 87 / 226

87
Location Recorder Model PD606
Chapter 5: Recording/Playback
1) While stopped, press the [SHIFT] key to enter shift mode, followed by the [FILE SEL / DRV, PAT.]
key.
The display changes to show the screen for selecting a drive. On the screen, the current
selection is initially highlighted.
2) Use the [MENU] dial to select the desired drive (the DVD drive or a partition) and press the
[ENTER/YES] key.
The selected drive is loaded and the display shows the Home screen of the current drive as
below (in the both examples below, no recording has been made to the current drive).
<When the DVD drive is selected>
<When partition 2 is selected>
<Note>:
You can also bring up the screen for selection a drive (as shown above) by the
following methods.
1) While stopped, press the [SHIFT] key to enter shift mode, followed by the [ENTER/YES] key.
The display shows the MENU list screen for selecting the desired main menu.
2) Use the [MENU] dial to select "DRV/PAT SEL" and press the [ENTER/YES] key.
The display shows the screen for selecting a drive as above.
The PD606 is equipped with the DVD multi drive and hard disk drive.
Before recording, select the drive to which recording is made. By default, partition 1 (PT01) on
the hard disk drive is selected as the current drive.
To record to a DVD-RAM disk or another partition, select the desired drive by following the
procedure below.
In the procedure below, it is assumed that a formatted DVD-RAM disk is set to the DVD drive.
8
TU
7
PQRS
GHI
4
JK
5
space
1
AB
2
LIGHT EXIT
MONO
ST
SOLO
C2
C3
C4
MS
FILE SEL TIME QUICK SET
MONITOR
4
3
2
1
5
6
L
R
ON
OFF
POWER
DVD HDD
ACCESS
PD606 LOCATION RECORDER
SHIFT CONTRAST MENU DRV,PAT. TC SET
ENTER / YES
BATT
1 / 3 / 5 + 2 / 4 / 6
ST BUS
READY TRK
C1
LINK MASTER
SHIFT DRV,PAT.
FILE SEL
Selecting the drive for recording