![background image](http://html1.mh-extra.com/html/formax/fd-6100/fd-6100_service-manual_2320033046.webp)
ISSUE
: 21/09/03
FD 6100 MAINTENANCE
MANUAL
REVISION
: 2.1
SECTION
: 01
PAGE 45
CONTENTS
4.3.2
FEEDER AB CLUTCHES SETTING
PURPOSE: To ensure the correct document pre-loading position and to ensure as well the proper
synchronisation between feeders A and B:
-
A too low stopping position (clutch delay too long) causes deformation of
thin and medium-thickness documents by the stop and consequently misalignment
from both bins.
-
A Too high stopping position (clutch delay too short) includes risks of
gripping defaults of thick documents by the base and of misalignment with a second
document.
ADJUSTMENT PROCEDURE:
-
To control the stop position for the feeder A-B, it is necessary to select a job which uses the
envelope feeder as well as feeder A (or B).
-
Load feeder A with only one document, but without any envelope in the feeder E.
-
Start the job (push the START key).
-
Rotate the feeder A-B, without disconnect it, in order to look at the document stop position.
-
If the position isn’t correct (see the picture below), it is necessary to apply the “A & B
CLUTCHES SETTING” procedure to adjust the timing value.
-
Perform again this adjustment until the stop position is correct, then apply the same procedure
for the feeder B
ALLOWED STOP POSITION
ALLOWED VARIATION