ISSUE
: 21/09/03
FD 6100 MAINTENANCE
MANUAL
REVISION
: 2.1
SECTION
: 01
PAGE 41
CONTENTS
Message displayed
Likely Cause
Remedy
REMOVE THE DOCUMENTS
FROM THE ENTRY OF
TRAYS A + B
Document Jam
Clutch badly set
Clear the paper path in the
feeder.
Check the setting of the
feeder AB clutches
NO DOCUMENT IN THE
TRAY(S)
Sensors faulty
Check the sensors in the
service mode.
CHECK THAT DOCUMENTS
ARE MOVING CORRECTLY OUT
OF TRAYS A,B or C
Sensors faulty or feeder AB
clutches badly set
Check the feeders sensors
in the service mode.
Check the setting of the
feeder AB clutches
REMOVE DOCUMENTS
FROM TRAY A
The AUTOSTART sensor is
faulty
Check the sensor in the
service mode.
DUPLICATE DETECTION,
CHECK CONTENTS OF
ENVELOPE
Faulty "DD-x" sensor
Check the faulty sensor in
the service mode
CHECK PAPER PATH OF
TRAY C
Rollers clogged up.
Path C sensor faulty
Clean the rollers
Check the sensor in the
service mode
CLOSE TRAY C
Sensor faulty
Check the sensor in the
service mode.
OPEN THEN CLOSE THE
MACHINE
The machine was unable to
run through its normal cycle.
Check all the paper path and
perform a power cycle
(OFF/ON)
