ISSUE
: 21/09/03
FD 6100 MAINTENANCE
MANUAL
REVISION
: 2.1
SECTION
: 01
PAGE 42
CONTENTS
4.2 FUNCTIONAL
FAULTS
SYMPTOMS
Likely Cause
Remedy
The machine pre-load feed the
documents from AB to the pre-loaded
position then stop
Bad setting of the clutches
Check the setting of the
feeder AB clutches
After 3000 cycles, the machine get
blocked
The authorization code was not entered
Set the authorization code
Inadequate moistening
Set the moistening position
Job mis-setting
Check that the moistening is set in the job
selected
Bad fold lengths
Check that the fold length / envelope high
are consistent
Bad inserting of the document
Check the envelope stop position. Clean
the inserting rollers.
Envelope not/bad closed
Set of document to be inserted too thick
Try with a thinner set.
Job miss-setting
Check that the moistening is set in the job
selected
Exit roller wet
Clean the exit roller
Bad/no moistening
Envelope flap out of specification
Check the envelope flap shape and high in
the specification
Offset between documents from feeders
A and B
Bad setting of the clutches
Check the setting of the
feeder AB clutches
Document set ejected below the
envelope
The envelope height doesn't match with
the job setting
Check the job and the envelope
Envelope not placed properly in the feeder
E
Check the envelope orientation in the
feeder E
Document set ejected after the envelope
Sensor "REF-ENVELOPE" faulty
Check sensor in the service mode
Inserting rollers clogged up
Clean the inserting rollers
Paper jams
Bad envelope inserting position
Adjust the envelope inserting position.
