100-09-21
100-09-21
Powertrain Diagnostic Routines Identification
DIAGNOSIS AND TESTING (Continued)
ROUTINE 6: NOTICEABLE DECREASE IN VEHICLE DRIVING RANGE (LEAD ACID VEHICLES)
TEST STEP
ACTION TO TAKE
•
Is the vehicle equipped with traction battery heaters?
No =
INFORM the customer that
the decrease in vehicle
driving range may be due to
harsh driving or storage
conditions, or not allowing
the vehicle to charge to the
full state of charge (SOC).
6-3 CHECK STATUS OF HEATER PRESENT SIGNAL
•
With key ON, monitor BCM PID HTRPRST.
Yes =
INFORM the customer that
the decrease in vehicle
driving range may be due to
harsh driving or storage
conditions, or not allowing
the vehicle to charge to the
full state of charge (SOC).
•
Does the HTRPRST PID indicate YES?
No =
GO to 6-4.
6-4 CHECK HEATER PRESENT SIGNAL FROM CONTACTOR BOX
•
Remove the traction battery and connect Traction Battery High-Voltage
Yes =
REPLACE the BCM.
Lockout and Diagnostic Tool to the traction battery high-voltage two-pin
REFER to
Section
C3994M.
No =
GO to 6-5.
WARNING: The traction battery contains high-voltage
components and wiring. High-voltage insulated safety gloves and face
shield must be worn when carrying out the following steps. Failure to
follow this warning may result in severe personal injury or death.
•
Connect Traction Battery High Voltage Service Cord to traction battery
support tray in-line C1935F and in-line C1935M.
•
Connect Traction Battery Low Voltage Service Cord to traction battery
support tray in-line C1939F and in-line C1939M.
•
Connect 104-Pin Breakout Box (BOB) to BCM C1986, C1987 using the
BCM/TIM BOB Adapter Cable and Overlay; leave the BCM
disconnected.
•
With key OFF, measure the resistance between BOB pin A31 and ground
(BOB pin A33).
•
Is the resistance less than 20 ohms?
6-5 CHECK CIRCUIT 3007 (P/Y) FOR OPEN
•
With key OFF, disconnect contactor box C1982 and measure the
Yes =
GO to 6-6.
resistance of the P/Y wire between pin 14 on contactor box C1982 and
BOB pin A31.
•
Is the resistance less than 5 ohms?
No =
REPAIR the P/Y wire.
6-6 CHECK HEATER JUMPER CIRCUIT 1161 (DB/O) FOR OPEN
•
With key OFF, disconnect contactor box C1864 and measure the
Yes =
REPLACE the contactor
resistance of the DB/O wire between pins D and E on contactor box
box. REFER to
Section
C1864.
•
Is the resistance less than 5 ohms?
No =
REPLACE high-voltage
harness (10B700).
2001 Ranger EV, 01/2001
Summary of Contents for 2001 Ranger
