FOR-A HVS-300HS, Operation Manual

Page: 89 / 114

79
18-3. Saving Data to USB Flash Memory
This section explains how to save the panel settings to the USB memory by using a "data.all" file
as an example.
(1) Insert the USB flash memory into the USB port.
(2) Press the MENU button, then press the 9/FILE button to open the FILE top menu.
(3) Turn F1 to select SAVE, and then press F1 or the PAGE DOWN button to open the
[FILE-SAVE] menu.
FILE :>LOAD > SAVE >UPDATE
TOP : 101MB
(4) Turn F1 to select ALL to the
EXT
(File Extension) item.
(5) Turn F3 to select data. (See section 18-5 "Moving between Directories in the USB Flash
Memory.") Press F3 to confirm the file selection.
FILE : EXT : CTRL : <DIR>.. 1/1
SAVE : =
ALL : =SAVE :data 101MB
(6) When the data is sent to the flash memory, the message “SAVE?” will appear. Press F3
again to store the data to the flash memory. A "beep" sound will be heard when the data is
saved.
If the same file exists in the USB flash memory:
A message “OVERWRITE?” will pop up that warns you that if you overwrite the existing file.
Turn F2 to select CANCEL, OVERWR(overwrite) or RENAME.
To Rename the File:
If you wish to rename the file to save it, turn F3 to select RENAME and refer to the section
18-7. "Renaming Files in the USB Flash Memory" to give a new name to the file.
IMPORTANT
When pressing a control push-button, press it down lightly and release it within 1 sec.
Note that if you press and hold a control for more than 1 sec., related operation will be
cancelled. Do not remove the USB flash memory while the access lamp is flashing.
This could corrupt the stored data or damage the USB flash memory.