FOR-A HVS-300HS, Operation Manual

Page: 85 / 114

75
Data not saved in the event memory
All SETUP menu settings
All FILE menu settings
STILL images
USER TRANS and ADV CTRL settings in the TRANS menu
(6) Press a number button (0-9) on the Keypad to store the event.
If an Event is Already Saved to a Button:
When ENT/STORE is pressed, the light of the buttons (0 to 9) are off if no events are saved.
The number buttons light up if events are already saved. If you press a button where an event
is already saved , it flashes. Pressing the button again overwrites the event. If you press
another button that has no event before overwriting, the event will be saved to that button.
If you cannot overwrite data, change
OVER WR
to ENABL (ENABLE) in the [EVENT-
RECALL] menu. (See section 17-3. "Overwrite Protection".)
17-2. Recalling Events
17-2-1. Using DIRECT Operation
If using the direct operation, the events can be most quickly recalled. However, users cannot
select the loaded data at recalling events. To use the direct recall, previously set the DIRECT
item to ON in the menu.
(1) Press the ±/EVENT button at the top right-hand side of the menu display.
(2) Turn F1 to select an event page in the [EVENT MEMORY] menu.
(3) Press the number button where the needed data is stored. The selected event will be
applied to the panel.
To Set DIRECT to ON:
When pressing ±/EVENT, the [EVENT MEMORY] menu is automatically displayed. Turn F2
to set
DIRECT
to ON.
EVENT : PAGE :DIRECT :PAGECLR:LAST : 1/1
MEMORY : =0 : =
ON : =ALL : :
17-2-2. Using the RECALL Button
To Recall Events (Fastest method):
(1) Press the ±/EVENT button at the top right-hand side of the menu display.
(2) Press the number button where the needed data is stored.
(3) Press the RECALL button. The selected event will then be applied to the panel.
MENU/DIRECT PATT/EVENT/KEY PAD
7/SET UP
4/WIPE
1
8/STILL
5/P in P
2/KEYER
9/FILE
6/MATT
3/DSK
MENU
DIRECT PATT
±/EVENT
CLR/TRANS RATE 0 /RECALL
. (DOT)
ENT/STORE
±/EVENT button
0 to 9
RECALL button