44
7-4. Additional Transition Settings
7-4-1. Fader Limit
The fader limit setting determines how far your transition does or does not proceed
electrically. When performing transitions (mix or other) there may be times when you want
the transition to the next signal to only complete to a certain degree instead of fully switching
from one picture to another. In this case, you will need to limit the transition range of the fader
lever process. The fader limit setting procedure for each signal layer is described below.
Setting Fader Limit Values
The fader limit for each signal layer can be set in the following parameters in the menu.
Signal layer
(Transition type)
Setting Parameter
DSK (MIX)
Sets at DSK of the FADER LIMIT line in TRANSITION menu
or
LEVEL of the KEY TRANS line in DSK menu.
BKGD (MIX, FAM,
NAM, WIPE, and DVE)
Sets at BKGD of the FADER LIMIT line in TRANSITION menu.
KEY1 (MIX, WIPE, and
DVE)
Sets at KEY1 of the FADER LIMIT line in TRANSITION menu
or
LEVEL of the KEY TRANS line in KEY1 menu.
KEY2 (MIX, WIPE, and
DVE)
Sets at KEY2 of the FADER LIMIT line in TRANSITION menu
or
LEVEL of the KEY TRANS line in KEY2 menu.
QUICK SET
You can quick set fader limit by first physically setting the fader lever to the point that
you want a translation to finish. With the fader at this position, press and briefly hold
down the FADER LIM button. This will become the current electrical value at the fader
position as the FADER LIMIT setting.
Fader Limit ON/OFF Settings
The fader limit ON/OFF setting for each signal layer should be done as follows in the table
below.
Signal layer
(Transition type)
Setting parameter or button
DSK (MIX)
Sets ON/OFF for LIMIT of the KEY TRANS line in DSK menu.
BKGD (MIX, FAM,
NAM, WIPE, and DVE)
Press to turn on/off the FADER LIM button in the TRANSITION
section.
KEY1 (MIX, WIPE, and
DVE)
Press to turn on/off the FADER LIM button in the TRANSITION
section
or
sets ON/OFF for LIMIT of the KEY TRANS line in KEY1
menu.
KEY2 (MIX, WIPE, and
DVE)
Press to turn on/off the FADER LIM button in the TRANSITION
section
or
sets ON/OFF for LIMIT of the KEY TRANS line in KEY2
menu.
