horizontal/vertical) and a positive (+) adjustment means moving right/down (for horizontal/vertical). These
adjustments are relative to the current edges.
IEDGE [<
type
>
=
<
value
>]
where
Type Value
L
– Left edge
Signed integer, must be within current left edge range.
R
– Right edge
Signed integer, must be within current right edge range.
T
– Top edge
Signed integer, must be within current top edge range.
B
– Bottom edge
Signed integer, must be within current bottom edge range
RESET
– Reset all edge adjustments to default values (no adjustments).
Input Picture Adjustments
This command is used to get or set the input picture adjustments. This includes the brightness (overall, red, green,
blue), contrast (overall, red, green, blue), hue, and saturation. To set an input adjustment, specify <type>=<value>.
IPADJ [<
type
>
=
<
value
>] … [<
type
>
=
<
value
>]
where
Type Value
Brightness
BO – Overall
87.8 to 112.2 % (dependent on hardware)
BR – Red
-10.0 to 10.0 %
BG – Green
-10.0 to 10.0 %
BB – Blue
-10.0 to 10.0 %
Contrast
CO – Overall
(Value depends on input video signal level;
70.0 to 140.0 % for standard computer signal).
CR – Red
-10.0 to 10.0 %
CG – Green
-10.0 to 10.0 %
CB – Blue
-10.0 to 10.0 %
H – Hue
-90 to 90 degrees
S – Saturation
0 to 200 %
R – Reset all input adjustments
to default values
(NA)
Input Aspect Ratio
This command is used to get or set the input aspect ratio. The aspect ratio is the ratio of the input number of active
horizontal pixels to the input number of active vertical lines. To set the aspect ratio, specify [ratio type]. [value] must
be specified for a custom ratio.
OASPR [
ratio type
] [
value
]
where
ratio type
0
– 4:3 ratio; [value] parameter not needed.
1
– 16:9 ratio; [value] parameter not needed.
2
– custom ratio (requires [
value
] parameter to be specified).
value
custom aspect ratio value in floating point format. Must be specified
when [ratio type] is set to 2.
Output Format Configuration: Video Standard and Component Video
The following command is used to get or configure the output video standard and component video. To configure an
output format parameter, specify <type>=<value>.
Manual # 26-0109901-00 / Revision C
SmartVIEW – Computer – to – Video Down Converter 29
