System Configuration: Diagnostics
Diagnostic Menu
Test Front Panel
Test I2C Bus
This menu contains selections to perform the following:
·
Test the LCD display and front panel buttons
·
Test the system internal device control bus
System Configuration: Diagnostics: Test Front Panel
This selection starts a non-destructive system test that exercises all pixels on the LCD display and requests the
operator to press and release each button. All pixels on the LCD display should illuminate and no errors should be
reported for the button press and release tests.
System Configuration: Diagnostics: Test I
2
C Bus
This selection starts a non-destructive system test that verifies the operation of the internal data bus used to control
the input video decoder, the Genlock decoder, the output video encoder, and the non-volatile memory storage device
The tests takes a few minutes and cannot be interrupted. PASS should be displayed for all listed devices.
System Configuration: SysReset
This menu option allows the system non-volatile memory to be reset to its initial factory configured state. All saved
view settings, input video format edge adjustments, brightness settings, etc. will be reset. A confirmation message
will be displayed to allow the user to accept or cancel this operation.
22 Smart
VIEW – Computer – to – Video Down Converter
Manual # 26-0109901-00 / Revision C
