Flavor Burst TS 44BEV, User Manual

Page: 76 / 100

75
6. To sanitize the Blending Head between
servings, hold a container under the
dispensing spout and press INJECTOR
FLUSH once. Sanitizer solution will flow for
a few seconds and automatically shut off.
NOTE:
IF NO “INJECTOR FLUSH” KEY ON
THE SCREEN, SEE THE “ENABLE THE
INJECTOR FLUSH FUNCTION” SECTION.
7. If no flavor is desired (i.e.
– to draw vanilla),
simply deselect any selected flavor entry by
pressing it. Select a serving size and draw
a serving until a beep sounds.
Setting Serving Size Timing
The TS 44BEV has a program functioned into
the electronics that allows the operator to have
the flavor flow shutoff automatically at a preset
time while drawing a serving. The operator
simply determines the length of time it takes to
draw a desired serving size and then programs
the sizes into the Touchscreen.
Setting the
serving size timing is only necessary when the
TS 44BEV system is set to run based on
serving size (see
“Serving Mode Options”).
Ensure that the freezer is set to the desired
product flow rate according to the freezer
manufacturer’s instructions.
1. Using a stop watch, record how long it takes
to draw each serving size according to your
preference (small, medium, large and extra-
large). Start timing from the moment the
draw handle is open fully till fully closed.
2. The Touchscreen should show Small,
Medium, Large and Extra Large keys above
the menu flavors. If not, follow the
instructions in the previous section
“Enabling the Timed Serving Size Draw
Mode.
”
3. From the main menu screen, press the
SETUP key in the upper left corner. Enter
the password if required.