Flavor Burst TS 44BEV, User Manual

Page: 70 / 100

69
11.
On the “Initial Unit Setup Powered by the
P2
Cable Connector” screen, check the box
under the A column in the “1-4” row. Press
the box to select it. Also, select the box in
the B column in the “5-8” row. Only these
boxes should be checked for this setup.
NOTE:
IF YOUR SETUP IS UNUSUAL, YOUR
TECHNICIAN MAY ADJUST THESE
SETTINGS UPON SETUP.
12.
Using the “<” and “>” keys, scroll through
the op
tions in the two “Type of Equipment”
boxes to select BEVERAGE FLAVORS.
NOTE:
IF “BEVERAGE FLAVORS” IS NOT
APPEARING AS AN OPTION, BE SURE THE
CORRECT BOXES HAVE A CHECK-MARK.
ALSO, MAKE SURE YOU ARE ON THE
CORRECT SCREEN. YOU SHOULD BE ON
THE SCREEN
THAT SAYS “POWERED BY
THE P2 (NOT P3)
CABLE CONNECTOR” AT
THE TOP. IF IT SAYS “P3”, CLEAR OUT THE
CHECKED BOXES,
PRESS THE “BACK”
BUTTON TO RETURN TO THE CORRECT
SCREEN AND REPEAT STEPS 11-12.
13. Press DONE to return to the main screen.
Testing the TS 44BEV System
Once the system is enabled to dispense flavors,
test each pump to ensure they all dispense
properly and that the Blending Assembly
operates correctly.
1. The Touchscreen should be programmed
with a list of menu flavors. If it is not, skip
ahead to the section ASSIGNING
FLAVORS TO THE MENU to set up the
flavor labels for your system. If the screen
has flavors listed different than the ones
currently in the containers, you may
proceed with these instructions first and
change the menu later.
2. Select Spout A.
3. If the screen shows serving sizes (Small,
Medium, Large, Extra Large), press and
deselect “Medium” so that
no sizes are
selected.
4. Select all four flavors on the screen.