www.eu.fishersci.com/fisherbrand
35
3.3 System Start Up
3.3.1 Plug in the Power Cord, Turn on Power
After turning on the power, system displays system type, serial number (S / N) for
5 seconds. At this point, system runs self-testing programs in the background.
System automatically checks water pressure, determines the water supply
situation. If no water is supplied, or inlet pressure is too low, monitor displays
"Low Pressure" as shown below, and system goes to standby.
3.3.2 Start Up the System
When the START button is pressed, system enters operational mode after an
automatic flush of the RO membrane for 180 seconds. System automatically
detects the quality of the RO water, discharges it to the drain if not meeting
quality parameters, or sends it to the water tank if it passes quality parameters.
At system initial start-up, or after installing a new RO membrane, allow system
to run at least one hour to clean up the RO membrane.
After the initial installation of a new system, it may take 2 hours or longer before
you can dispense water as system is conducting initial RO rinsing and filling the
Accu500
S/N: S0RD50503
14/10/17 14:59:59
RO: 12.0
µ
S/cm 25
LOW PRESSURE
