www.eu.fishersci.com/fisherbrand
28
3) Connect 1/4 inch tubing to the "TO TANK" on the system and "INLET" at the
base of the PE tank, and connect the 3/8 inch tubing to the "FROM TANK" on
the system and "OUTLET" at the base of the PE tank.
4) Take the transparent tubing with check valve from the system accessories
bag. Cut it to the appropriate length for your use. Connect it to the overflow
sprout on the PE tank, and put the end with check valve into a sink. Tubing
length should be just long enough so that the check valve end is hanging in
the sink.
5) Screw the Tank Vent Filter to the top of the PE tank (see picture Tank Top
View)
6) Plug the wire from the liquid level sensor on the tank to the Sensor inlet at the
back of the system. Tighten the cap.
7) Install the faucet:
a) Remove the knob and water outlet from the package. Twist on the water
outlet to the knob, then remove the yellow tape from O-ring.
b) Screw on the assembled faucet to the tank till finger tight.
8) Initiate the system and check if there is any leakage from connections, reinstall
the units if leaking.
9) Install tank sanitization module if necessary.
2.4.5 Connecting the Tubing to the Drain
Cut appropriate length from the provided 1/4 inch tubing. Then connect it to
DRAIN at the back of the system. Put the other end into a sink.
Knob
Connect there
Water outlet
Nut
O-ring
