Fischer Panda 45i pms, User Manual

Page: 104 / 212

Maintenance Instructions
Seite/Page 104 - Kaptitel/Chapter 7: Maintenance Instructions 8.10.14
Fig. 7.7-4: Oil screen
Oil screen with generators with EA300 engines
The oil screen should be cleaned every 500 operating hours: to do so follow
the instructions in the engine manual.
Use spanner size 17 mm.
Sample picture
Fig. 7.7-5: Oil screen sealing ring
6. Preparing a new filter
Clean the engines’ filter holder brush a thin oil layer on the
sealing of the new filter.
7. Mounting the new filter
Carefully screw in the new filter by hand. It must not be tightened too much. Screw in the oil drain screw again
and tighten is with the wrench. Use a new sealing for the oil drain screw.
8. Fill in oil. (oil fill capacity: see attachment)
Fill the engine oil into the engine via feed hopper. Check oil-level after every 2 litres with the oil dipstick.
9. Check proper filling level. See section 7.6, “Checking oil-level,” on page 99.
When the proper filling level is reached, screw in the oil cap again. Run the engine for 10 minutes and then turn it
off. Check the oil-level once more after several minutes with the oil dipstick. If it is too low, refill some oil.
10. Clean up
Wipe off all oil splashes from the generator and make sure that the drain screw has no leak.
7.7.1 After the oil change
• Put the oil dipstick back into the check rail.
• Close the oil filling cap.
• Remove potential oil stains and splashes from the generator and surroundings.
• Close the generator casing.
• Remove lock against accidental generator start.
• Duly dispose of used oil and filter.
Used oil is very toxic and must not be disposed with domestic waste. It is prohibited to dispose used oil with
waste water! Make sure that used oil is disposed properly (e.g.: where oil is bought or at collection stations).