Fiery E-750, Configuration Manual, Page: 71 / 184

4
4-15 Network Setup options
option (DHCP or BOOTP), the IP address can change. Select No to assign the E-750
a static IP address. If you select No, you proceed to the IP Address option, where you
manually set the IP address.
Select protocol
DHCP/BOOTP [DHCP]
This option appears only if you answered Yes to Enable Auto IP Configuration. Select
the protocol over which the E-750 should search for its IP address. Both DHCP and
BOOTP allow the E-750 to obtain the Ethernet IP address and Subnet
Mask
automatically.
Depending on your network, the E-750 might be assigned a different address after you
restart the E-750. With the DHCP setting, the E-750 can be assigned a different
address even if it is not restarted. Make sure the network is already configured properly
for the protocol you select.
Get Gateway Addr
Yes/No [Yes]
Use this option to assign the gateway address automatically for printing with TCP/IP.
IP Address
[127.0.0.1]
Enter the E-750 IP address for Ethernet. This IP address, unlike an IP address set
automatically, remains the same if you restart the E-750. You must change the default
to a valid address for your network. For information about setting up printing with
TCP/IP, see
Chapter 2 .
Subnet Mask
This option lets you modify the subnet mask for printing with TCP/IP over Ethernet.
To set the subnet mask, enter one of the following values:
• 255.0.0.0 if the IP address starts with a number less than 128
• 255.255.0.0 if the IP address starts with a number from 128 through 191
• 255.255.255.0 if the IP address starts with a number greater than 191
N
OTE
:
Confirm the subnet mask setting with your network administrator before
proceeding. In some cases, the required setting may be different from that listed.