34
Check functions accept various values value and targets for P1 and P2. Settings for P1 and P2 are
independent to each other.
10.4.1 Check types and target
Below 2 types of check target are available.
•
Quantity Check: - Check target = quantity value
•
Weight check Count: - Check target = weight value.
Unit weight is the basic of all piece count transaction / process. Unit weight can be created and obtained through
one of the below methods: -
a.
Direct entry method.
b.
Employ last unit weight when power on
c.
Recall from quick PLU.
10.4.1.1 Direct entry method
1.
Enter check type: -
For quantity check, press
[QTY]
and press
[Check]
.
For weight check, press
[@WT]
and press
[Check]
.
2.
Instrument displays
Low
on LCD1.
3.
Enter Lo weight check limit and press
[Print/M+]
.
4.
Instrument displays
High
LCD1.
5.
Enter Hi weight check limit the press
[Print/M+]
.
6.
Instruments returns to normal operation status.
At this point, weight check limit is saved and in effect.
10.4.1.2 Employ last check type and limits when power on
Last check type and limits (before powered off) will be employed when powered on again.
10.4.1.3 Recall check type and limits from quick PLU
•
For quantity check: - Refer to paragraph
11.2.2
for details.
•
For weight check: - Refer to paragraph
11.3.2
for details.
10.4.2 Hints for entering Lo and Hi limits
•
For normal comparison, set both Lo and Hi limits.
•
To check only if result is lower than or equal to Lo (result ≤ Lo), set Hi Limit = 0.
•
To check only if result is higher than or equal to Hi (result ≥ Hi), set Lo Limit = 0.
•
To check if result is equal to a specified value, set both Hi Limit and Lo Limit = the specified value.
10.4.3 Cancel check function
To clear check function, follow paragraph
10.4.1.1
and enter zero value by pressing
[CE/x10]
in steps
2
and
4
.
