Fiat SEDICI, Owner'S Handbook Manual, Page: 108 / 266

107
SYSTEM OPERATING
INSTRUCTIONS
Automatic operation
You can let the climate control system
work automatically. To set the system in
fullyautomatic operation, follow the pro-
cedure below.
❒
Set the desired temperature by turning
the temperature selector (
1 ).
❒
Turn the blower speed selector ( 2 ) to
the “AUTO” position.
❒
Turn the air flow selector ( 3 ) to the
“AUTO” position.
Then the blower speed selector/ air intake
selector (
2 ) and air flow selector ( 3 ) are
controlled automatically to maintain the
set temperature.
The air conditioning switch ( 1 ) is to be se-
lected manually according to your taste.
When you turn the air conditioning switch
off, the climate control system cannot
lower the inside temperature below out-
side temperature.
To turn the climate control system off,
turn the blower speed selector (
2 ) to the
“OFF” position.
NOTE
❒
To find your comfortable zone, start
with the 22°C (72°F) setting.
❒
If you turn the temperature selector ( 1 )
to the highest or lowest limit, the cli-
mate control system will operate at the
maximum cooling or heating and the
blower will run at nearly full speed.
❒
To avoid blowing cold air in cold weath-
er or hot air in hot weather, the system
will delay turning on the blower until
warmed or chilled air is available.
79J069
Defrost (g)
Temperature- controlled air comes out of
the windshield defroster outlets, the side
defroster outlets and the side outlets.
NOTE When the air flow selector ( 3 ) is
turned either to “Heat & defrost ( f )” or
“Defrost ( g )”, the air conditioning system
will come on and the “FRESH AIR” mode
will be selected automatically. But in very
cold weather, the air conditioning system
will not turn on.
79J098
069-128 Fiat16 New GB 3-09-2008 11:59 Pagina 107