A. Technical appendix
86
Festo GDCC-CECX-K-D1-EN en 0802a
Setting the module address
The address switch is generally located on the right side of the peripheral modules under
the lower cover. The bus plug is located under the upper cover. The address must be set
before the device is assembled. In combination with the GFDM diagnostic system, the ad-
dress switches of all peripheral modules must be set to 0.
1
Bus plug (be-
hind cover)
2
Recess for H-rail
3
Address switch
(module addresses)
4
H-rail latching
lever
Figure A.8 Address switch and bus plug of a peripheral module (example)
You set the module addresses of the peripheral modules as follows:
1.
Remove the side cover of the address selector switch.
Caution
Damage to components.
Make sure when setting the module addresses that you do not
damage any adjacent components with the screwdriver.
2.
Check the address setting and if necessary set it to 0 using a suitable screwdriver.
3.
Replace the side cover (to protect against dirt and damage by electrostatic discharge
upon contact).
4
1
2
3
