Contents and general safety information
8
Festo GDCC-CECX-K-D1-EN en 0802a
Designated use
The controller CECX-K-D1 is designed for installation in a control cabinet. It is available in
the following version:
Product version
Description
Controller CECX-K-D1
The designated use of the device in this product version *) is to construct a
diagnostic module for pneumatic systems (Festo Energy Monitoring GFDM). The
device performs the following tasks for this purpose:
−
Monitoring of flow rate (Q) and pressure (p) in the supply line
−
Calculation of the cycle consumption (controlled by trigger signals)
−
Monitoring of the diagnostic data on the basis of stored reference values
*) Special firmware is part of the product version.
Table 0.1 Possible product designs
Use this product only as follows:
-
only in industrial applications,
-
in accordance with its designated use,
-
in its original condition without unauthorised modifications; only the conversions or
modifications described in the documentation supplied with the product are permit-
ted,
-
in faultless technical condition.
If additional commercially-available components such as sensors and actuators are con-
nected, the specified limits for pressures, temperatures, electrical data, torques, etc. must
not be exceeded.
Please comply with national and local safety laws and regulations.
Use only modules from the CECX series to set up the controller CECX-K-D1.
The use of modules from this series in combination with modules from other series is not
permitted. The products and/or system components described may only be used for the
applications specified in the technical description and only in combination with recom-
mended and/or approved third-party devices.
The products described have been developed, produced, tested and documented in com-
pliance with the relevant safety standards. If the instructions and safety information de-
scribed for the designated use are observed, the product does not normally pose any risk
of damage to property or the health of people.
