Felder Hammer, Setup Manual

Page: 26 / 104

For machines with additional rip capacity of 48" ( 1250mm ) , additional supports nee d
to be assembled (see next step).
For machines with
31" (800mm) capacity, once the supports are in place, with th e
screws in location, the table can placed on top of the screws and brought into
alignment with the cast iron table, ideally using a straight edge as shown below. The
exact alignment details can be found in tolerancing information.
(picture showing full length 31"( 800mm ) Rip capacity)
Continued…
11.Assembly