Each time switch 4 is pressed, the activated light will
move one step to the right and the switch 12 LED
will illuminate momentarily. Press and hold switch 4
until the activated light rotates right to the desired
position.
NOTE
If switch 4 is pressed and held allowing the
activated take-down lights to rotate more
than approximately 1-1/2 revolutions, an error
indication will occur. Press switch 1 (RESET)
to clear the error indication and start over.
5.
Switch 5 (RELAY A).
Press switch 5 to activate the auxiliary
device, such as headlight flashers or grille lights,
connected to the relay A output. The installer should
inform you what device (if any) is connected to the
relay A output. The switch 5 LED will illuminate.
Press switch 5 again to deactivate the auxiliary
device and extinguish the switch 5 LED.
6.
Switch 6 (MODE 1).
Press switch 6 to activate Mode 1. In
this keyboard configuration, three lights rotate at 90
FPM. The LED’s in the V-shaped display will flash
indicating the lights are activated and the switch 6
LED will illuminate. Press switch 6 again to deacti-
vate Mode 1. The LED’s in the V-shaped display and
the switch 6 LED will extinguish.
7.
Switch 7 (MODE 2).
Press switch 7 to activate Mode 2. In
this keyboard configuration, four lights rotate at 90
FPM and three lights oscillate to the front. Also, the
auxiliary devices (if any) connected to the relay B and
C outputs will activate. The installer should inform
you what devices (if any) are connected to the relay B
and C outputs. The LED’s in the V-shaped display
will flash indicating the lights are activated and the
switch 7 LED will illuminate. Press switch 7 again to
deactivate Mode 2. The LED’s in the V-shaped
display and the switch 7 LED will extinguish.
8.
Switch 8 (MODE 3).
Press switch 8 to activate Mode 3. In
this keyboard configuration, all seven lights rotate in
synchronization at 90 FPM creating a center-out
pattern. The LED’s in the V-shaped display will flash
indicating the lights are activated and the switch 8
LED will illuminate. Press switch 8 again to deacti-
vate Mode 3. The LED’s in the V-shaped display and
the switch 8 LED will extinguish.
9.
Switch 9 (V-BAR LEFT).
Press switch 9 to activate a lightbar
generated, left arrow directional signal to the front of
the vehicle. The LED’s in the V-shaped display
simulate the pattern being executed and the switch 9
LED will illuminate. Press switch 9 again to deacti-
vate the directional signal. The LED’s in the V-
shaped display and the switch 9 LED will extinguish.
10. Switch 10 (V-BAR CENTER OUT).
Press switch 10 to activate a lightbar
generated, center out directional signal to the front of
the vehicle. The LED’s in the V-shaped display
simulate the pattern being executed and the switch
10 LED will illuminate. Press switch 10 again to
deactivate the directional signal. The LED’s in the V-
shaped display and the switch 10 LED will extin-
guish.
11. Switch 11 (V-BAR ALTERNATE).
Press switch 11 to activate a lightbar
generated, alternating flash pattern(four lights in the
center, then two outer lights on both sides) to the
front of the vehicle. The LED’s in the V-shaped
display simulate the pattern being executed and the
switch 11 LED will illuminate. Press switch 11 again
to deactivate the directional signal. The LED’s in the
V-shaped display and the switch 11 LED will extin-
guish.
12. Switch 12 (V-BAR RIGHT).
Press switch 12 to activate a lightbar
generated, right arrow directional signal to the front
of the vehicle. The LED’s in the V-shaped display
simulate the pattern being executed and the switch
12 LED will illuminate. Press switch 12 again to
deactivate the directional signal. The LED’s in the V-
shaped display and the switch 12 LED will extin-
guish.
E.
Keyboard Configuration 6
(RECOVERY).
NOTE
Refer to figure 1-5 while reading paragraph
1-6.E.
1.
Switch 1 (RESET).
Press this switch to extinguish all
lights (if activated) in the lightbar. The RESET LED
will illuminate and the reflectors rotate to the “home”
position. All other LED’s will extinguish and acti-
vated functions will deactivate.
1-9
Summary of Contents for VISION
Page 2: ......
