1-5. SS2000 SMARTSIREN INTERFACE.
If the SS2000 SmartSiren interface is installed,
operate switch 8 (usually Mode 3) or the foot switch
to activate the SS2000 pursuit function. The
SS2000’s Mode 3 will be activated and sound the
selected siren tone. Operate switch 8, or the foot
switch, again to deactivate Mode 3 and the SS2000
pursuit function.
Refer to the Installation and Operating Instruc-
tions supplied with the SS2000 for additional infor-
mation.
CAUTION
Improper warning system operation may re-
sult if the SS2000 Mode 3 switch is operated
when the SS2000 SmartSiren interface is
installed. Do not operate the SS2000 Mode 3
switch when the SS2000 SmartSiren interface
is installed.
1-6. KEYBOARD CONFIGURATIONS.
IMPORTANT
The control head’s LED display simulates the
light pattern(s) being executed by the warning
system. The display is intended ONLY as a
guide and NOT as an indication of proper
warning system operation.
Before using the warning system, its operation
should be observed from outside the vehicle.
The available “standard” keyboard configura-
tions are as follows:
•
Keyboard Configuration 2 (POLICE A).
•
Keyboard Configuration 3 (POLICE B).
•
Keyboard Configuration 4 (FIRE A).
•
Keyboard Configuration 5 (FIRE B).
•
Keyboard Configuration 6 (RECOVERY).
•
Keyboard Configuration 7 (CLEAR-
BOARD).
•
Keyboard Configuration 8 (DEMO - sales
use only).
Determine which keyboard configuration is
selected. The installer or person responsible for
configuration will provide this information. Read and
understand the applicable keyboard configuration
description below.
1-3. LED ILLUMINATION INTENSITY ADJUSTMENT.
The bright LED’s provide maximum visibility in
high ambient lighting conditions. The RESET LED
illumination intensity can be adjusted from bright
illumination to dimmed, dimmer, or extinguished for
night operations. The backlighting illumination
intensity does not change, but does extinguish when
the RESET LED is extinguished.
To adjust, proceed as follows:
A.
If any functions are activated, press the
RESET switch. The RESET LED should be illumi-
nated.
B.
Press the RESET switch again to decrease
the LED illumination intensity.
C.
Continue to press the RESET switch until
the desired LED illumination intensity and back-
lighting are achieved.
NOTE
Operating the foot switch (if installed), or
pressing any control head switch (except
RESET) will cause the LED illumination in-
tensity to revert to bright illumination.
Also, the LED illumination intensity will
revert to bright illumination when the vehicle
ignition switch, or user-supplied switch, is
switched “off” and switched “on”.
1-4. FOOT SWITCH.
Operating the optional foot switch will alternate
between the switch 8 function (usually Mode 3) and
the switch 7 function (usually Mode 2). If installed,
operate the foot switch to activate the switch 8
function. Operate the foot switch again to deactivate
the switch 8 function and activate the switch 7
function. Operating the foot switch a third time does
not deactivate the warning system; it will deactivate
the switch 7 function and reactivate the switch 8
function.
To deactivate a foot switch activated function,
operate the corresponding control head switch.
NOTE
Since the SS2000 SmartSiren® interface is
associated with the switch 8 function, the
siren will deactivate when the switch 7 func-
tion is activated.
1-3
Summary of Contents for VISION
Page 2: ......
