Fayat CC424CHF, Instruction Manual

Page: 139 / 158

Maintenance - 1000h
4812159501_D.pdf 2018-04-12
Wheel gear - Checking the oil level/Filling the
oil
Fig. Oil level check - wheel gear
1. Level plug
2. Filling plug
1
2
Place the roller on a level surface. Move the machine
until the inspection/filling holes are in position for filling.
1 Fig. Wheel gear
2
Refill with new oil, about 0.8 l (0.85 qts). Use
transmission oil according to the lubricant specification.
Ensure that the oil level reaches up to the lower edge
of the plug hole.
Clean and refit the plugs.
Hydraulic filter
Change
Remove the filter (1) and deliver to special waste
handling. This is a single-use filter and cannot be
cleaned. Remove the filter (1) and deliver to special waste
handling. This is a single-use filter and cannot be
cleaned.
Figure. Engine compartment, left
1. Hydraulic fluid filter
1
Thoroughly clean the filter holder sealing surface.
Apply a thin coat of fresh hydraulic fluid to the rubber
gasket on the new filter.
Screw the filter on by hand, firstly until the filter gasket
makes contact with the filter base. Then rotate a
further ½ turn.
127