Maintenance measures - 500 h
4812159501_D.pdf
2018-04-12
The engine fuel filter - replacement/cleaning
1
Figure. Engine compartment, left side
1. Prefilter
The fuel filter is placed on the left side of the engine
compartment.
Unscrew the bottom and drain off any water, and then
replace the filter unit.
Figure. Engine compartment, right
side.
1. Fuel filter
1
Replace the fuel filter, located on the right side of the
engine compartment.
Start the engine and check that the filter is well sealed.
Drum - oil level
Inspection - filling
Fig. Drum, vibration side
1. Filler plug
2. Level plug
2
1
Position the roller with the filler plug (1), the large plug,
at the highest point in its rotation.
Wipe clean around the level plug (2), the small plug,
and remove the plug.
Make sure that the oil level is up to the lower edge of
the hole. Top off with fresh oil if the level is low. Use oil
as specified in the lubricants specification.
When removing the filler plug, wipe any metal
accumulated on the plug magnet off. Make sure that
plug seals are intact and replace with new seals if not.
Refit the plugs and check that they are tight by driving
the roller and then rechecking.
119
Summary of Contents for CC424CHF
