Faster GLOVEFAST ASEPTIC, Operating And Maintenance Manual

Page: 28 / 65

a D:GROUP Company
0254EN
– Rev. 06 – 09/2019
Page 28 of 65
Exhaust Filter (F2)
17. Rotate the fastening threaded bars [7] to lift down the plenum group [8] and to release the HEPA
filter.
(Rear view)
18. Proceed as indicated in above 6, 7 points.
19. Lock the HEPA filter by rotating the fastening threaded bars [7].
20. Re-close the internal panel [3] with the special fastening screws.
21. Re-close the control board [1] with care and lock it with the closures [2].
22. Proceed with the necessary control-calibration procedures of the laminar air-flow isolator.
ATTENTION: Gaskets should be of the EPDM closed-cell type and have no interstices in the joining
points.
ATTENTION: Having replaced the filters, proceed to check the calibration of the air flow
parameters. Carry out a check with a particle counter and possibly a leak test (DOP
test). For these operations, contact your local distributor.
8
7