Faster GLOVEFAST ASEPTIC, Operating And Maintenance Manual

Page: 37 / 65

a D:GROUP Company
0254EN
– Rev. 06 – 09/2019
Page 37 of 65
12 TECHNICAL SPECIFICATIONS
External structure AISI 304 stainless steel. Perfectly air-tight structure with work
area under negative pressure.
Work chamber
Made from glazed AISI-304 stainless steel with radiussed
angles
Work surface AISI 316L stainless steel sheet (removable).
Spillage tray AISI 304 stainless steel, located under the work surface
Filtration (Main, LAF, Exhaust
Pass Box Outlet and Inlet)
H14 HEPA filters, according to EN 1822-1;
Main motor-fan Direct coupling centrifugal type. Designed to ensure a good
protective barrier even in the case of an exhaust motor-fan
failure. IP-55 protection factor
Exhaust motor-fan Direct coupling centrifugal type. Designed to keep the internal
pressure constant and to create a protective barrier on the
glove opening in case of glove brake.
Speed regulation Automatic regulation to keep constant air-flow speed (0.45
m/s) and the internal pressure (+75 Pa) even in the presence
of progressive clogging of the two HEPA filters.
Airflow sensor Continuous monitoring and displaying of the laminar air-flow
velocity and the pressure in the work chamber. These values
are measured by one airflow fan-sensor and a pressure sensor
unaffected by variations in temperature and humidity
Front glass Safety stratified glass.
Lighting Lighting system placed outside the work area.
Control panel Soft-touch keyboard on the front
Power supply
220-230V - 50 Hz single phase
Testing Electronic "light scattering" meter, hot-wire and fan
anemometer, noise meter, DOP test, luxmeter, and smoke test
at the factory