![background image](http://html.mh-extra.com/html/farmtek/growers-supply-hydrocycle/growers-supply-hydrocycle_manual_545430020.webp)
20
20
115295
Revision date: 03.21.18
4a
ASSEMBLY TANK STAND: 125 GALLON TANK
The 125 gallon tank stand consists of a single top plate and frame, four (4) leg supports, and eight
(8) struts. Complete these steps to assemble the stand for the 125 gallon tank:
1. Assemble four (4) leg supports by threading an FALB04B locking nut onto a 113030S03
adjustable footer and thread that assembly into leg tube.
IMPORTANT:
Install adjustable footer at end of leg support tube that includes the strut
mounting holes. See diagram.
2. Set distance from top of adjustable foot to leg assembly at approximately 1" or so.
3. Next, take the AQ138 top plate and frame section and attach leg assemblies as shown using
the 115303 flat head bolts.
4. Tighten using a 7/32" Allen wrench. Verify that bolt holes for struts are oriented so struts align
with mounting holes. See diagrams on next page.
ATTENTION:
Mounting holes on legs are in different positions. If legs are installed incorrectly,
mounting holes in struts will not align with mounting holes in frame top. Use a strut to match
hole locations during leg installation. Rotate leg as needed and tighten.
Use these parts to construct stand for 125 gallon tank:
• AQ138 One-Piece Top Plate & Frame
• AQ129 Support Leg
• AQ133 Strut
• 113030S03 Adjustable Footer
• FALB04B (NUT 3/8-16 ZINC EACH)
• 115303B (3/8"-16 X 3"L FLAT HEAD BOLT ZINC)
• FAG338B (HEX CAP 5/16 X 3" ZINC – EACH)
• FAME07B (BULK FLT WSH 5/16" ZINC – EACH)
• FALB02B (NUT BULK 5/16-18 ZINC – EACH)
1"
FALB04B
Nut
113030S03
Adjustable Footer
AQ129
Support Leg
AQ129
Support Leg
Strut
Mounting
Hole
AQ138
1-Piece Top
115303B
Flat Head Bolt
AQ129
Support Leg
Assemble & Set Tank Stands