10
10
115295
Revision date: 03.21.18
Required parts:
• 110611
3-Way Corner Insert (8)
• S15P016 Square Tube @ 16" (4)
• 104779
Square Tube @ 96" (8)
• 112375
Square Tube @ 15-3/4" w/ 45° Cuts (28)
• FA4572
Tek Screws
• 100442
Magnetic Nut Setter
ATTENTION:
Do not install any Tek screw along top rail of raft
bed frame. Surface is reserved for installation of raft bed liner
and retaining bars.
Install all corner tubes flush with top of 3-way fitting as shown.
ASSEMBLY STEPS – MAIN FRAME
Raft Bed Assembly
Complete these steps:
1. Construct main frame using corner fittings and the upper and lower tubes.
2. After perimeter frame is assembled, install vertical supports. Secure each support to upper
and lower tubes using two (2) FA4572 Tek screws for each beveled support.
Use photos below and diagrams on previous pages to assemble
one (1) 8' x 8' raft bed frame.
16”
Install vertical tube tight
against 3-way corner and
3-way tee fittings (if present).
Evenly space all beveled vertical supports
throughout length and width of raft bed frame.
Center
2a
ASSEMBLY NOTE:
Install Tek screws using a
clutched drill driver running approximately 750 RPM
while applying approximately 50 lbs of force.
Do not use an impact driver!
