3
Revision date: 03.21.18
115295
READ THIS DOCUMENT BEFORE YOU BEGIN
Thank you for purchasing the 115295 Aquaponic System. When properly assembled and maintained, this system will provide years of reliable service. These
instructions include helpful hints and important information needed to safely assemble and properly maintain the system. Please read and understand these
instructions
before
you begin. If you have any questions during assembly, contact customer service.
ASSEMBLY PROCEDURE
Following instructions as presented will help
ensure proper assembly of your aquaponic
system. Steps outlining assembly are as follows:
1. Verify that all parts are included in the
shipment. Notify customer service for
questions or concerns. See below.
2. Read and understand these instructions and
the information included with the shipment
before
you begin.
3. Gather tools and recruit assistants.
4. Assemble aquaponic system.
5. Read additional information as presented.
Important Information
SAFETY PRECAUTIONS
• Wear eye protection.
• Wear gloves when handling metal pipes.
• Use a portable GFCI (Ground Fault Circuit
Interrupter) when working with power tools and
cords.
UNPACK AND IDENTIFY PARTS
The following steps will ensure that you have all
the necessary parts
before
you begin assembly.
1. Unpack contents of shipment and place where
you can easily inventory parts. Refer to Bill of
Materials/Spec Sheets.
2. Verify that all parts listed on Bill of Materials/
Spec Sheets are present. If anything is
missing or you have questions, consult all
diagrams and photos for clarification, or
contact Customer Service.
NOTE:
At this time, you do not need to open
the plastic bags containing smaller parts
such as fasteners or washers (if equipped).
WARNING:
Enlist the services of an
experienced electrician when connecting
power to the pump and other electrical
devices.
All wiring to be completed according to
established codes and practices.
DROWNING HAZARD:
Never allow
children or others within the boundary of
the tanks, raft bed, and pump stations at
any time.
Always have an assistant present during
harvest, tank cleaning, and system
maintenance to prevent accidents.
FLOOR DRAIN:
A floor drain is recommended to
allow easier cleaning and draining of tanks. Keep
area around tanks and plumbing clean.
REQUIRED TOOLS
The following list identifies the main tools needed to
assemble the aquaponic system. Additional tools
may be needed.
• Tape measure and marker.
• Variable speed drill (cordless with extra
batteries works best).
• Small hammer and gloves.
• Level (4' or longer– recommended) and line
level.
• Utility knife or scissors.
• Tool to cut PVC tubing.
• Assorted hand tools common to construction,
plumbing, and electrical work.
• Drill bit set with assorted bits.
• Hole saw bits: 2-1/4", 2-1/2", & 3".
• Large adjustable pliers (3"-4" jaw).
• 7/32" hex (Allen) wrench or bits — preferably
bits to attach to power driver or drill.
Used to
install 115303B screws.
WINDOW KITS FOR FISH TANKS
If a window kit was purchased for any fish-
holding tank, install the window kit before tank
preparation and setting tank in place on tank
stand. Consult instructions with kit or online.
CUSTOMER-SUPPLIED MATERIALS
This system includes all parts needed for
assembly
except weights for the aeration
system
. See Section 10 for details.
Additionally, mounting air pumps in a location
that best serves your needs requires a
customer-supplied mounting surface and
fasteners to secure pumps to that surface.
Changes to recommended layout may require
purchase of additional plumbing fittings and
related PVC pipe.
