16
16
115295
Revision date: 03.21.18
INSTALL RAFT BED LINER — continued
3
Raft Bed Liner Installation
10. Move to remaining corners and repeat steps
to temporarily secure them to frame.
7. Repeat steps to secure liner material.
8. Check bottom of liner for wrinkles and remove
these by working material toward free edge.
11. While adding water, remove any excess
material that touches ground. Allow a couple
inches to remain for final steps.
9. Start adding water to raft bed to allow water to
seat liner inside frame.
NOTE:
Do not fill more than 1"- 2". Water level
to stay below hole in bulkhead plate.
12. Fill bed with 1"- 2" of water. Water level to
remain below hole in bulkhead plate (2d).
13. Install pre-drilled aluminum retaining strap.
6. Cut material as needed to allow it to fit more
evenly at corners.
ATTENTION:
Do not drop any sharp objects
into bed liner at any time. Contact your sales
representative for products used to repair
damage to liner if needed.
ASSEMBLY NOTE:
Install Tek screws using a clutched drill driver running
approximately 750 RPM while applying approximately 50 lbs of force.
Do not use an impact driver!