- 16 -
I
T
ALIANO
E
NGLISH
F
RANÇAIS
E
SP
AÑOL
P
ORTUGUÊS
D
EUTSCH
Mi 2425
System programming
The following programming allows you to
personalise the operation mode of button “1”
used to deactivate the ring tones and the GC-GE
terminals and send the floor call to the systems
with the same user address (internal stations in
parallel). See table 2.
To make the programming it is necessary:
enter the programming mode following the
instructions described in “
Enter the
programming mode”;
keep pressed the button “
” for more than 4
seconds; yellow LED starts flashing;
a - keep pressed the button “
” for more than
4 seconds; yellow LED starts quickly flashing;
b - press the button “1” once to enable operating
mode 0 (you hear a sharp tone); within 2
seconds press the button “1” again to disable
operating mode 0 (you hear a low tone);
c - press the button “
” to confirm and go on
to program the next mode;
you must repeat steps a, b and c to program all
operating modes in table 2;
after you have completed the operation and
confirmed operating mode 7 with the button
“
”, press the button “
” and replace the
handset to exit the programming phase.
Note.
Programming will not be changed if the
values of all modes are not entered correctly.
- Programming example of page 8.
Additional functions
Call floor
To have the floor call connect the apparatus as
illustrated in the diagram.
Call Repeat
You can connect the apparatuses as illustrated in
the diagram below to sent the videointercom ring
to other locations in the house.
Resetting the default programming values
To reset the videointercom default programming
values and delete all the variations made in the
programming mode you must:
enter the programming mode following the
instructions described in “
Enter the program-
ming mode”;
press the buttons 5, 4, 3, 2 and 1 successively;
the tone indicates that the default values have
been restored.
Table 2 - System programming codes
Default
To enable
To disable
Operating modes
value
press 1 time
press 2 times
button "2"
button "2"
mode 0
send floor call to other internal stations in parallel
(1)
disabled
enabled
disabled
mode 1
button “1” deactivates all ring tones
(2)
disabled
enabled
disabled
mode 2
button “1” deactivates all ring tones and button tones
(2)
disabled
enabled
disabled
mode 3
button “1” does not deactivate ring tones and button tones
(2)
disabled
enabled
disabled
mode 4
reserved; disabled
disabled
-
disabled
mode 5
the GC-GE terminals are activated upon call from external door station
(3) disabled
enabled
disabled
mode 6
the GC-GE terminals are activated upon intercom call
(3)
disabled
enabled
disabled
mode 7
reserved; disabled
disabled
-
disabled
(1) From the internal station connected to the floor call button (terminal A1) and with operating mode 0 enabled, the floor call is also sent to the other
apparatuses in parallel.
(2) If modes 1, 2 and 3 are disabled, press the button “1” for 4 seconds , without a conversation in progress, to deactivate the external and videointercom
ring tones. To reactivate the ring tones, press the button “1” again for 4 seconds; you hear the confirmation tone.
(3) If modes 5 and 6 are disabled, the GC and GE terminals are activated to send the calls.
Example of system programming to enable operating mode 0 and 2 and to disable all the others operating modes
