40i P - Installation/Operation - Appendix - (32/32)
4.2.4
Material returning terms
When returning the DRO, pack it in its original package and with its original packaging material. If not
available, pack it as follows:
Get a cardboard box whose three inside dimensions are at least 15 cm (6 inches) larger than those of the
unit. The cardboard being used to make the box must have a resistance of 170 Kg (375 lb.).
When sending it to a Fagor Automation office for repair, attach a label indicating the owner of the unit,
person to contact, type of unit, serial number, symptom and a brief description of the problem.
Wrap the unit in a polyethylene roll or similar material to protect it.
Pad the unit inside the cardboard box with polyurethane foam on all sides.
Seal the cardboard box with packing tape or industrial staples.
Maintenance
Cleaning:
An accumulation of dirt in the equipment can act as a screen preventing proper dissipation of the heat
generated by the internal electronic circuits with the consequent danger of overheating and DRO fault.
Accumulated dirt can also, in some cases, provide a conductive path for electricity which could give rise to
faults in the internal circuits of the equipment, especially in high humidity conditions.
To clean the equipment nonabrasive dish-washing detergents are recommended (in liquid, never powder
form) or 75% isotropic alcohol with a clean cloth. DO NOT USE aggressive solvents, (benzol, acetones,
etc.) which could damage the materials the equipment is made with.
Do not use high pressure compressed air to clean the item as this could give rise to an accumulation of
charges which in turn lead to electrostatic discharges.
The plastics used in the front panel of the DRO stand up to: Grease and mineral oil, alkalis and bleaches,
dissolved detergents and alcohol.
Avoid the effect of solvents such as Chlorohydrocarbons, Benzol, Esters and Ethers because these could
damage the plastics with which the front of the equipment is made.
Preventive Inspection
If the DRO does not come on press the rear switch for starting, make sure it is properly connected and
being supplied with the proper mains voltage.
Fagor shall not be held responsible for any printing or transcribing errors in this manual and reserves the
right to make any modifications to the characteristics of their products without prior notice.
FAGOR AUTOMATION S. COOP.
Bª San Andrés Nº 19
Apdo de correos 144
20500 Arrasate/Mondragón
- Spain -
Web: www.fagorautomation.com
Email: [email protected]
Tel.: (34) 943 719200
Fax: (34) 943 791712
