40i P - Installation/Operation - DRO operation - (11/32)
2.5
Special functions.
It gives access to the specific milling functions.
2.5.1
Cycles.
The DRO allows storing 99 cycles, numbered from 1 to 99. The
cycles may be executed, deleted or edited at will.
The screen shows the data of the selected cycle so it can be
identified easily.
Deletes the selected cycle.
To edit the values of the selected cycle.
Execute (run) the cycle.
The cycles that may be programmed are:
ꞏ Bolt-hole drilling
ꞏ Linear drilling
ꞏ Grid pattern drilling
ꞏ Go to:
2.5.1.1
Options for each cycle.
Exit cycle editing.
Show graphics. See
" Simulation / execution special
modes:" (page 14)
.
Save cycle data in a cycle number so it can be edited or
executed later on.
Function
