40i P - Installation/Operation - DRO operation - (6/32)
2.1.2.3
Degrees / Degrees-Minutes-Seconds
Toggles the axis display units between degrees and degrees, minutes, seconds.
2.1.3
Rad / Diam
Toggles the X axis display between radius and diameter
2.2
Set/Clear
There are two ways (modes) to set a value (Set) on the display or zero it (Clear).
2.2.1
In " Set" mode (indicated with an " S" on the upper status bar):
To preset a value for an axis.
To zero the axis, either preset a 0 value using the previous
keystroke sequence or use this other sequence (clear + axis).
2.2.2
In " Clear" mode (indicated with a " C" on the upper status bar)
Set the display to zero.
To preset a value:
And validate the data by pressing this key.
Or ignore it by pressing this key.
Display
Deg / DMS
Display
Rad / Diam
Display
Set/Clear
Value
Value
